Dell PowerConnect 5424

114 Configuring System Information
Modifying a DHCP IPv4 Interface
1 Open the DHCP IPv4 Interface page.
2 Modify the fields.
3 Click Apply Changes .
The entry is modified, and the device is updated.
Deleting a DHCP IPv4 Interface
1 Open the DHCP IPv4 Interface page.
2 Click Show All .
The
DHCP IPv4 Interface Table opens.
3 Select a DHCP client entry.
4 Select the Remove check box.
5 Click Apply Changes .
The selected entry is deleted, and the device is updated.
Defining DHCP IPv4 Interfaces Using CLI Commands
The following table summarizes the equivalent CLI commands for defining DHCP clients.
The following is an example of the CLI command:
Table 6-18. DHCP IPv4 Interface CLI Commands
CLI Command Description
ip address
dhcp
[
hostname host-name]
To acquire an IP address on an Ethernet interface from the
Dynamic Host Configuration Protocol (DHCP).
console> enable
console# config
console (config#) interface ethernet g1
console (config-if)# ip address dhcp 10.0.0.1 /8