Configuring System Information 133
When defining a new DNS server, the following additional parameters are available:
•
Supported IP Format
— Specifies the IP format supported by the server. The possible values are:
–
IPv6
— IP version 6 is supported.
–
IPv4
— IP version 4 is supported.
•
IPv6 Address Type
— When the server supports IPv6 (see previous parameter), this specifies the type
of static address supported. The possible values are:
–
Link Local
— A Link Local address that is non-routable and used for communication on the same
network only.
–
Global
— A globally unique IPv6 address; visible and reachable from different subnets.
•
Link Local Interface
— When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
–
VLAN1
— The IPv6 interface is configured on VLAN1.
–
ISATAP
— The IPv6 interface is configured on ISATAP tunnel.
Adding a DNS Server
1
Open the
Domain Naming System (DNS)
page
.
2
Click
Add
.
The
Add DNS Server
page opens:
Figure 6-38. Add DNS Server
3
Define the relevant fields.
4
Click
Apply Changes
.
The new DNS server is defined, and the device is updated.
To Next Page
Loading...
