Dell PowerConnect 5424

216 Configuring System Information
• Recipient IP — Indicates the IP address to whom the traps are sent.
–
Notification Typ e — The notification sent. The possible field values are:
–
Traps — Traps are sent.
–
Informs — Informs are sent.
•
SNMPv1,2 — SNMP versions 1 and 2 are enabled for the selected recipient. Define the following
fields for SNMPv1 and SNMPv2:
•
Community String (1-20 Characters) — Identifies the community string of the trap manager.
–
Notification Version — Determines the trap type. The possible field values are:
–
SNMPv1 — SNMP Version 1 traps are sent.
–
SNMPv2 — SNMP Version 2 traps are sent.
•
SNMPv3 — SNMPv3 is used to send and receive traps. Define the following fields for SNMPv3:
•
User Name — The user to whom SNMP notifications are sent.
•S
ecurity Leve l — Defines the means by which the packet is authenticated. The possible field values
are:
–
No Authentication — The packet is neither authenticated nor encrypted.
–
Authentication — The packet is authenticated.
–
Privacy — The packet is both authenticated and encrypted.
•
UDP Port (1-65535) — The UDP port used to send notifications. The default is 162.
•
Filter Name — Includes or excludes SNMP filters.
•
Timeout (1-300 ) — The amount of time (seconds) the device waits before resending informs.
The default is 15 seconds.
•
Retries (1-255) — The amount of times the device resends an inform request. The default is 3.
•
Remove Notification Recipient — When checked, removes selected notification recipients.
When adding a Notification Recipient, the following additional parameters are available:
• Supported IP Format — Specifies the IP format supported by the recipient. The possible values are:
–
IPv6 — IP version 6 is supported.
–
IPv4 — IP version 4 is supported.