222 Configuring System Information
•
Supported IP Format
— Specifies the IP format supported by the server. The possible values are:
–
IPv6
— IP version 6 is supported.
–
IPv4
— IP version 4 is supported.
•
IPv6 Address Type
— When the server supports IPv6 (see previous parameter), this specifies the type
of static address supported. The possible values are:
–
Link Local
— A Link Local address that is non-routable and used for communication on the same
network only.
–
Global
— A globally unique IPv6 address; visible and reachable from different subnets.
•
Link Local Interface
— When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
–
VLAN1
— The IPv6 interface is configured on VLAN1.
–
ISATAP
— The IPv6 interface is configured on ISATAP tunnel.
•
Firmware Download —
The Firmware file is downloaded. If
Firmware Download
is selected, the
Configuration Download
fields are grayed out.
•
Configuration Download —
The Configuration file is downloaded. If
Configuration Download
is
selected, the
Firmware Download
fields are grayed out.
•
Download via TFTP
— Enables initiating an image download via the TFTP server.
•
Download via HTTP
— Enables initiating an image download via the HTTP server.
Firmware Download
•
Server IP Address —
The Server IP Address from which the firmware files are downloaded.
•
Source File Name (1-64 Characters) —
Indicates the file to be downloaded.
Active Image
•
Active Image
— The Image file that is currently active.
•
Active Image After Reset
— The Image file that is active after the device is reset.
Configuration Download
•
Server IP Address
— The Server IP Address from which the configuration files
• are downloaded.
•
Source File Name (1-64 Characters)
— Indicates the configuration files to be downloaded.
•
Destination
— The destination file to which the configuration file is downloaded.
To Next Page
Loading...
