Configuring System Information 225
•
Link Local Interface
— When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
–
VLAN1
— The IPv6 interface is configured on VLAN1.
–
ISATAP
— The IPv6 interface is configured on ISATAP tunnel.
•
Firmware Upload
— Indicates that the upload is for firmware. If
Firmware Upload
is selected,
the
Configuration Upload
fields are grayed out.
•
Configuration Upload
— Indicates that the upload is for configuration files. If
Configuration Upload
is selected, the
Firmware Upload
fields are grayed out.
•
Upload via TFTP
— Enables initiating an image upload via the TFTP server.
•
Upload via HTTP
— Enables initiating an image upload via the FTP server.
Software Image Upload
•
TFTP Server IP Address
— The TFTP Server IP Address to which the Image file is uploaded.
•
Destination File Name (1-64 Characters) —
Indicates the Image file path to which the file is
uploaded.
Configuration Upload
•
TFTP Server IP Address —
The TFTP Server IP Address to which the Configuration file is uploaded.
•
Destination File Name (1-64 Characters) —
Indicates the Configuration file path to which the file is
uploaded.
•
Transfer File Name —
The software file to which the configuration is uploaded.
This list of
user-defined configuration files only appears if the user created backup configuration files.
For example, if the user copied the running configuration file to a user-defined configuration file
called BACKUP-SITE-1, this list appears on the File Upload to Server page and the BACKUP-SITE-1
configuration file appears in the list.
The possible field values are:
–
Running Configuration —
Uploads the Running Configuration file.
–
Startup Configuration —
Uploads the Startup Configuration file.
–
<filename>
— Uploads the specified configuration file. The filename was determined by the
user at download.
To Next Page
Loading...
