EasyManua.ls Logo

Dell PowerConnect 5424

Dell PowerConnect 5424
444 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
254 Configuring Device Information
Set Port
— The port is either locked or unlocked. The possible field values are:
Unlocked
— Unlocks Port. This is the default value.
Locked
— Locks Port.
Learning Mode
— The port learning mode. The possible field values are:
Classic Lock
— The port will not learn new IP addresses. A computer with a different address
cannot connect to the network via the port.
Limited Dynamic Lock
— The port will learn a limited number of new IP addresses and then
lock.
Max Entries (1-128)
— The number of new IP addresses the port will learn before being locked, if set
to Limited Dynamic Lock Learning Mode.
Action on Violation
— The action to be applied to packets arriving on a locked port. The possible
field values are:
Forward
— Forwards the packets from an unknown source, however, the MAC address is not
learned.
Discard
— Discards the packets from any unlearned source. This is the default value.
Shutdown
— Discards the packet from any unlearned source and locks the port. Port remained
locked until they are activated, or the device is reset.
Trap
— Enables traps being sent when a packet is received on a locked port.
Trap Frequency (1-1000000)
— The amount of time (in seconds) between traps. This field only
applies to Locked ports. The default value is 10 seconds.
Defining a Locked Port
1
Open the
Port Security
page.
2
Select an interface type and number.
3
Define the fields.
4
Click
Apply Changes
.
The locked port is added to the
Port Security Table
, and the device is updated.

Table of Contents

Other manuals for Dell PowerConnect 5424

Related product manuals