Dell PowerConnect 5424

294 Configuring Device Information
5 Define the Ty p e field.
6 Click Apply Changes .
The new source port is defined, and the device is updated.
Deleting a Copy Port from a Port Mirroring Session
1 Open the Port Mirroring page.
2 Select the Remove check box.
3 Click Apply Changes .
The selected port mirroring session is deleted, and the device is updated.
Configuring a Port Mirroring Session Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring a Port Mirroring session
as displayed in the Port Mirroring page.
The following is an example of the CLI commands:
Table 7-15. Port Mirroring CLI Commands
CLI Command Description
port monitor src-interface [rx | tx] Starts a port monitoring session.
Console(config)# interface ethernet g1
Console(config-if)# port monitor g8
Console# show ports monitor
Source Port Destination Port Type Status VLAN Tagging
----------- ---------------- ------------ ------- ------------
g8 g1 RX, TX Active No
g2 g8 RX, TX Active No
g18 g8 Rx Active No