Dell PowerConnect 5424

Configuring Quality of Service 415
Figure 9-2. Interface Settings
• Interface — The specific port or LAG to configure:
•
Disable "Trust" Mode on Interface — Disables Trust Mode on the specified interface. This setting
overrides the Trust Mode configured on the device globally.
•
Set Default CoS For Incoming Traffic To — Sets the default CoS tag value untagged packets.
The CoS tag values are 0-7. The default value is 0.
Assigning QoS/CoS settings for an interface:
1 Open the Interface Settings page.
2 Select an interface in the Interface field.
3 Define the fields.
4 Click Apply Changes .
The CoS settings are assigned to the interface.