EasyManua.ls Logo

Dell PowerConnect 5424

Dell PowerConnect 5424
444 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
88 Configuring System Information
Delay
— The amount of time it takes to reach the SNTP server.
Remove
— Removes a specific SNTP server from the
SNTP Server
list, when selected.
When adding an SNTP Server, the following additional parameters are available:
Supported IP Format
— Specifies the IP format supported by the SNTP server. The possible
values are:
IPv6
— IP version 6 is supported.
IPv4
— IP version 4 is supported.
IPv6 Address Type
— When the server supports IPv6 (see previous parameter), this specifies the type
of static address supported. The possible values are:
Link Local
— A Link Local address that is non-routable and used for communication on the same
network only.
Global
— A globally unique IPv6 address; visible and reachable from different subnets.
Link Local Interface
— When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
VLAN1
— The IPv6 interface is configured on VLAN1.
ISATAP
— The IPv6 interface is configured on ISATAP tunnel.
Adding an SNTP Server
1
Open the
SNTP Servers
page.
2
Click
Add.
The
Add SNTP Server
page opens:
Figure 6-12. Add SNTP Server
3
Define the
fields.
4
Click
Apply Changes
.
The SNTP Server is added, and the device is updated.

Table of Contents

Other manuals for Dell PowerConnect 5424

Related product manuals