Dell PowerConnect 5424 User Manual

90 Configuring System Information
Deleting the SNTP Server
1 Open the SNTP Servers page.
2 Click Show All.
The SNTP Servers Table opens.
3 Select an SNTP Server entry.
4 Select the Remove check box.
5 Click Apply Changes .
The entry is removed, and the device is updated.
Defining SNTP Servers Settings Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the SNTP
Servers page.
The following is an example of the CLI commands:
Table 6-9. SNTP Server CLI Commands
CLI Command Description
sntp server ipv4-address|ipv6-address|hostname
[poll] [key keyid]
Configures the device to use SNTP to request and
accept NTP traffic from as server.
console> enable
console# configure
Console(config)# sntp server 100.1.1.1 poll key 10
Console# show sntp status
Clock is synchronized, stratum 4, reference is 176.1.1.8
Reference time is AFE2525E.70597B34 (00:10:22.438 PDT Jul 5 1993)
Unicast servers:
Server Preference Status Last response Offset
[mSec]
Delay
[mSec]
--------- ---------- -------- --------------- ------ ------
176.1.1.8 Primary Up AFE252C1.6DBDDFF2 7.33 117.79
176.1.8.179 Secondary Unknown AFE21789.643287C9 8.98 189.19
Anycast server:

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation