Dell PowerConnect 6024 - Page 109

Configuring System Information 119
Modifying an SNTP Server
1 Open the SNTP Servers page.
2 Click Show All.
The SNTP Servers Table opens.
3 Select an SNTP Server entry.
4 Modify the relevant fields.
5 Click Apply Changes .
The SNTP server information is updated.
Deleting the SNTP Server
1 Open the SNTP Servers page.
2 Click Show All.
The SNTP Servers Table opens.
3 Select an SNTP Server entry.
4 Select the Remove check box.
5 Click Apply Changes .
The entry is removed, and the device is updated.
Defining SNTP Servers Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
SNTP Servers
page.
The following is an example of the CLI commands:
Console(config)# sntp server 100.1.1.1 poll key 10
Table 6-7. SNTP Authentication CLI Commands
CLI Command Description
sntp server {
ip-
address | hostname
}
[poll] [key
keyid ]
Defines an SNTP server that can be used for
synchronizing time information.
no sntp server
ip-
address
Removes a server from the list of SNTP servers.