Dell PowerConnect 6024 - Page 182

192 Configuring System Information
www.dell.com | support.dell.com
Deleting a TACACS+ Server from the TACACS+ Servers List
1 Open the TACACS+ Settings page.
2 Click Show All .
The
TACACS+ Table opens.
3 Select a TACACS+ Table entry.
4 Select the Remove check box.
5 Click Apply Changes .
The TACACS+ server is removed, and the device is updated.
Defining TACACS+ Servers Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring fields displayed in
the
TACACS+ Settings page.
Table 6-37. TACACS+ Settings CLI Commands
CLI Command Description
tacacs-server host {
ip-
address | hostname
}
[single-connection] [port
port-number
] [timeout
timeout ] [key key-string ]
[source
source ] [priority
priority ]
Specifies a TACACS+ server host.
no tacacs-server host
{
ip-address | hostname }
Deletes a specified TACACS+ server host.
tacacs-server key [
key-
string
]
Specifies the authentication and encryption
key used for all TACAS communication
between the router and the TACACS+
server. This key must match the encryption
used on the TACACS daemon. (Range:0-
128 characters)
no tacacs-server key Returns to the default.
tacacs-server timeout
timeout
Specifies the timeout value in seconds.
(Range: 1-30)
no tacacs-server timeout Returns to the default.
tacacs-server source-ip
ip-address
Specifies the source IP address. (Range:
Valid IP address)
no tacacs-server source-
ip
ip-address
Returns to the default.