Configuring Switch Information 259
Displaying the Port Table
1
Open the
Port Configuration
page.
2
Click
Show All
to display the
Port Configuration Table
.
Configuring Ports with CLI Commands
The following table summarizes the equivalent CLI commands for configuring ports as displayed
in the
Port Configuration
page.
Table 7-8. Port Configuration CLI Commands
CLI Command Description
interface ethernet
interface
Enters the interface configuration
mode to configure an ethernet type
interface.
description
string
Adds a description to an interface
configuration.
shutdown Disables interfaces that are part of the
currently set context.
set interface active
{ethernet
interface
| port-
channel
port-channel-
number
}
Reactivates an interface that is
shutdown due to security reasons.
speed {10 | 100 | 1000} Configures the speed of a given
ethernet interface when not using auto
negotiation.
duplex {half | full} Configures the full/half duplex
operation of a given ethernet interface
when not using auto negotiation.
negotiation Enables auto negotiation operation for
the speed and duplex parameters of a
given interface.
back-pressure Enables Back Pressure on a given
interface.
flowcontrol {auto | on |
off}
Configures the Flow Control on a
given interface.
mdix {on | auto} Enables automatic crossover on a
given interface or Port-channel.
To Next Page
Loading...
