Dell PowerConnect 6024 - Page 352

362 Configuring Routing
www.dell.com | support.dell.com
Authentication Mode — The interface authentication type, Password or MD5, used to
authenticate OSPF link state messages.
Authentication Password — Password used to authenticate OSPF link sate messages. The
maximum password length is eight characters.
Authentication Key-Chain — The MD5 key chain used to authenticate OSPF link sate messages.
Metric Value — The metric for this type of service on the interface. The possible field value range
is 1-65535.
Remove — When checked, removes an OSPF interface.
Adding an OSPF Interface
1 Open the Interface Parameters page.
2 Click Add to display the Add OSPF Interface page.
Figure 8-15. Add OSPF Interface
3
Complete the fields on the page .
4 Click Apply Changes .
The new OSPF interface is added to the device.