Dell PowerConnect 6024 - Page 353

Configuring Routing 363
Modifying OSPF Parameters
1 Open the Interface Parameters page .
2 Select an OSPF interface to display the field parameters for the table entry.
3 Modify the desired parameters.
4 Click Apply Changes .
The OSPF interface parameters are modified and saved to the device.
Removing an OSPF Interface
1 Open the Interface Parameters page .
2 Click Show All to display the OSPF Interface Table .
3 Select an OSPF interface.
4 Check the Remove check box.
5 Click Apply Changes .
The OSPF interface is removed.
Defining OSPF Interfaces Using UCLI Commands
The following table contains the CLI commands for defining OSPF interfaces.
Table 8-11. OSPF Interface CLI Commands
CLI Command Description
ospf Creates an OSPF routing process on an
interface.
ospf area
area-id Defines an interface area ID.
ospf enable Activates OSPF on an interface.
ospf priority
number-
value
Sets the router priority, which is used in
electing the designated router for the
network.
ospf hello-interval
seconds
Specifies the time interval between hello
packets the software sends on an interface.
ospf dead-interval
seconds
Sets the time interval during which hello
packets must not be sent before neighbors
declare the router down.
ospf retransmit-interval
seconds
Specifies the time interval between link-
state advertisement (LSA) retransmissions
for interface adjacencies belonging to the
interface.