Configuring Quality of Service 453
Figure 10-14. QoS Class Map Page
Class-Map Name
— The user-defined name of the class map.
IP ACL
— The IP ACL from the IP Access Control List (ACL). For more information about
defining IP-based ACLs, see "Defining IP based ACLs."
Match
— Criteria used to match IP addresses and /or MAC addresses with an ACL’s address.
Possible values are:
And
— Both the MAC-based and the IP-based ACL must match a packet.
Or
— Either the MAC-based or the IP-based ACL must match a packet.
MAC ACL
— The MAC ACL from the MAC Access Control List. For information about defining
MAC-based ACLs, see
"
Defining MAC based ACLs."
Remove
— When checked, removes the class map from the Class Map Table.
Adding a Class Map
1
Open the
QoS Class Map
page.
2
Click
Add
to display the
Add a Class-Map
page.
3
Enter a name (16 characters maximum) for the class map in the
Class-Map Name
field.
4
Do one of the following.
• To attach an IP ACL to the class map, check
IP ACL
and select an IP ACL from the
drop-down menu.
• To attach a MAC ACL to the class map, check
MAC ACL
and select a MAC ACL from
the drop-down menu.
To Next Page
Loading...
