Dell PowerConnect 6024 - Page 444

454 Configuring Quality of Service
www.dell.com | support.dell.com
5 Select either And or Or from the Match drop-down menu if both the IP ACL and
MAC ACL check boxes are selected.
6 Click Apply Changes .
The class map is created, and the device is updated.
Editing a Class Map
1 Open the QoS Class Map page.
2 Select a class map from the Class-Map Name drop-down menu.
3 Edit the remaining fields on the page as desired.
4 Click Apply Changes .
5 The class map is edited, and the device is updated.
Deleting a Class Map
1 Open the QoS Class Map page.
2 Select a class map from the Class-Map Name drop-down menu.
3 Check the Remove check box.
4 Click Apply Changes .
The class map is deleted, and the device is updated.
Displaying the Class Map Table
1 Open the QoS Class Map page.
2 Click Show All to display the Class Map Table page.
Defining QoS Class Maps Using the CLI Commands
The following is an example of the CLI commands:
console(config)# class-map class1 match-all
Table 10-13. QoS Class Maps CLI Commands
CLI Command Description
class-map
class-map-
name
[match-all |
match-any]
Creates a class map and enters class map
configuration mode.
match access-group
acl-
name
Defines the match criterion to classify traffic;
active only under class map configuration
mode.
show class-map [
class-
map-name
]
Displays all the class maps.