Dell PowerConnect 6024 - Page 450

460 Configuring Quality of Service
www.dell.com | support.dell.com
3 Enter a name for the policy in the New Policy Name field.
4 Do one of the following:
• To configure a class map for the class, click
Class Map and select a class map from the
drop-down menu.
• To configure a trust action a the class, click
Action , click Trust , and select a trust method
from the drop-down menu.
• To configure Set/Mark actions, click
Set , select a method from the drop-down menu and
enter a value in the
New Value field.
5 If you want to configure policing for the class, click Police , and select a policer type from the
drop-down menu.
• For an aggregate policer, select an aggregate policer from the
Aggregate Policer drop-
down menu.
• For a single policer, complete the information in the
Committed Information Rate
(CIR)
, Committed Burst Size (CBS) , and Exceed Action fields.
6 Click Apply Changes .
The policy and its first class are created, and the device is updated.
Adding a Class
1 Open the QoS Policy page.
2 Select a policy from the drop-down menu.
3 Edit the information in the fields on the page, and click Apply Changes .
The class is added to the policy, and the device is updated.
Deleting Policies:
1 Open the QoS Policy page.
2 Click Show All to display the Policy Table page.
3 Click Remove for each of the policies to be deleted, and then click Apply Changes .
The policies are deleted from the system, and the device is updated.
Defining Policies Using the CLI Commands
Table 10-15. Policy CLI Commands
CLI Command Description
policy-map
policy-map-
name
Creates a policy map, and enters policy
map configuration mod.