Dell PowerEdge R7625 - Page 112

Figure 79. C2-2-R2: 12 x 3.5-inch SAS3/SATA RAID (w/ APERC11_R2) w/ Rear 2 x 2.5-inch
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 77. 12 x 3.5-inch SAS3/SATA RAID (w/ APERC11_R2) w/ Rear 2 x 2.5-inch
Order From To
1 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
2 CTRL_SRC_SB1 (adapter PERC controller
connector) and BP_DST_SB1 (backplane signal
connector)
BP_DST_SA1 (rear backplane signal connector) and
BP_DST_SB1 (rear backplane signal connector)
3 CTRL_SRC_SA1 (adapter PERC controller
connector)
BP_DST_SA1 (backplane signal connector)
4 SIG_PWR_0 (system board power connector) BP_PWR_1 (rear backplane power connector)
112 Installing and removing system components