Installing the keyboard
1. Align the keyboard and route the cables back through to the bottom of the compartment.
2. Press and align the keyboard to its compartment.
3. Replace the screws to secure the keyboard to the computer.
4. Slide the keyboard trim and align it to its position on the computer. Ensure that the keyboard trim clicks into its place
5. Connect the keyboard data cables to the touchpad board.
NOTE: Ensure that you fold the keyboard data cable in perfect alignment.
6. Install the:
a) hard drive
b) battery
c) battery cover
7. Follow the procedure in After working inside your computer.
Memory modules
Removing the primary memory module
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a) battery cover
b) battery
c) base cover
3. To remove primary memory module:
a) Pry the retention clips away from the memory module until it pops up.
b) Lift the memory module and remove it from the computer.
Disassembly and reassembly
17
To Next Page
Loading...
