e) base cover
f) battery
g) battery cover
4. Follow the procedure in After working inside your computer.
System board
Removing the system board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a) SD card
b) battery cover
c) battery
d) base cover
e) hard drive
f) keyboard
g) hard drive cable
h) secondary memory
i) primary memory
j) WLAN card
k) WWAN card
l) M.2 SSD card
m) graphic card
n) power connector port
o) palmrest
p) I/O board (left)
q) I/O board (right)
r) heat sink
3. To disconnect and remove the eDP cable:
a) Remove the M2.5x5.0 screws that secure the shield to the system board [1].
b) Lift the metal shield away from the eDP cable [2].
c) Disconnect the eDP cable [3].
d) Lift the tab and disconnect the power connector cable [4].
36
Disassembly and reassembly
To Next Page
Loading...
