Installing the base cover
1. Slide the base cover to align with the screw holes on the computer.
2. Replace the M2.5X5.0 screws to secure the base cover to the computer.
3. Install the:
a) battery
b) battery cover
4. Follow the procedure in After working inside your computer.
WWAN card
Removing Wireless Wide Area Network - WWAN card
NOTE: Depending on the configuration you choose, you may or may not have WWAN card.
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a) battery cover
b) battery
c) base cover
3. To remove the WWAN card:
a) Disconnect and unroute the antenna cables connected to the WWAN card [1].
b) Remove the M2.0x3.0 screw that secures the WWAN card to the computer [2].
c) Remove the WWAN card from the computer [3].
20
Disassembly and reassembly
To Next Page
Loading...
