4. Flip the computer and tighten the 15 screws (M2.5x5.0, M2.0x3.0) at the bottom of the computer.
5. Install the:
a) keyboard
b) hard drive
c) base cover
d) battery
e) battery cover
6. Follow the procedure in After working inside your computer.
Fingerprint reader
Removing the fingerprint reader
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a) SD card
b) battery cover
c) battery
d) base cover
e) hard drive
f) keyboard
g) hard drive cable
h) secondary memory
i) primary memory
j) WLAN card
k) WWAN card
l) M.2 SSD card
m) graphic card
n) power connector port
o) palmrest
3. To remove fingerprint reader:
a) Peel the adhesive tape that secures fingerprint reader [1].
b) Remove and lift the M2.0X3 screws that secure metal bracket on the chassis [2].
c) Disconnect the cable and lift the fingerprint reader from the chassis [3].
Disassembly and reassembly
27
To Next Page
Loading...
