67
“difficult“ soils i.e. in which the use of custom soil coefficients a0 and a1 was
insufficient.)
Install, Sensor Calibration
Installs calibration information for a particular WET sensor.
Options: WET
A unique calibrations table is provided on disk for each individual sensor, with file
names ending in ".Cal". Only one digital sensor can be installed at any one time.
1. Connect your HH2 to your PC as described on page 61.
2. Select a device e.g. Install, Linearisation Table, WET to display a Windows
Open dialog.
3. Select the required table e.g.WET201023.Cal.
Once the sensor calibration is installed, the HH2 will be able to display readings -
providing the device is selected from the keypad (e.g. using Options, Device, WET).
Note: WET sensor calibrations cannot be altered by the user.
Note: Soil specific calibration tables for the WET sensor cannot be installed by the
user, only by Delta-T.
Help Menu
Selecting Help will show information about the version of this software.
See also page 2
To Next Page
Loading...