79
To Replace the Battery
When the HH2 reaches its low point, then you will have to replace the battery. To do
so, unclip the back panel by pressing downwards on the clip at the rear. You will find
the connector as shown above. It can only be fitted one way.
Let the HH2 sleep then remove the current battery and replace it with a new one.
You will have at least 30 seconds to replace the removed battery before the memory
will be lost.
Place the newly connected battery in the compartment and refit the cover, making
sure all the wires are tucked inside the case
Note: in case of problems changing the battery, it is advisable to download any
readings stored in the meter before replacing the battery. However, if you are
working away from a PC, then you should have enough time to replace the battery
without losing any readings.
The HH2 when using a new battery can take approximately:
2000 SM200, ML2 or Equitensiometer readings
1400 PR2 readings
before needing to replace the battery.
Note: this number of readings is presented as a guide only. Delta-T only guarantees
this number of readings under perfect conditions. The number of readings can be
reduced if the unit is kept awake, if the unit is used in temperatures which are not
suitable for the battery, or if the battery has poor performance and loses power
rapidly.
To Next Page
Loading...