63
HH2Read Menus
View Menu
This menu duplicates the left-hand row of buttons, giving information about the HH2
Moisture Meter:
• Firmware Version
• Battery Voltage
• Memory Available
• Table Status
Version
Select View, Version to display the current version of the firmware, that is, the
software embedded in the microprocessor in the Moisture Meter.
This is normally only needed when an upgrade or technical support is being
considered.
Battery
Select View, Battery to display the meter's battery status.
Memory
Select View, Memory to display the number of readings stored and the total
available.
Available memory
During any given field session the available memory depends on how many times you
change the meter settings.
The size of the memory also depends on whether you are using a Profile Probe -
which contains many sensors, or a device such as an ML2, with a single sensor.
See also: Maximum Number of Readings on page 83.
Table Status
Select View, Table Status to show what linearisation tables are loaded and their
status.
Note: Equitensiometers do not have a table.
If your table is faulty the HH2 will replace it with the default table.
See Linearisation Tables Format, page 76, for guidance on correcting faulty tables.
To Next Page
Loading...