Chapter 6 Fault Code Information|VFD-VL
6-4
Display
Description
Eov Eat oSt EpEE EEE
EFEE E10
C
eod :
aFult
DC BUS over-voltage at stop
Corrective Actions:
1. Check if the input voltage falls within the rated AC
motor drive input voltage range.
2. Check for possible voltage transients.
ELv Eat cAc Eel EEEE
EFEE E
11
C
eod :
a
F
u
lt
DC BUS voltage is less than Pr.06-00 during acceleration.
Corrective Actions:
1. Check if the input voltage is normal
2. Check for possible sudden load
ELv Eat cDe Eel EEEE
EFEE E12
C
eod :
a
F
u
lt
DC BUS voltage is less than Pr.06-00 during deceleration.
Corrective Actions:
1. Check if the input voltage is normal
2. Check for possible sudden load
ELv Eat rNo lma E DSP
EFEE E13
C
eod :
a
F
u
l
t
DC BUS voltage is less than Pr.06-00 during constant speed.
Corrective Actions:
1. Check if the input voltage is normal
2. Check for possible sudden load
ELv Eat oSt EpEE EEE
EFEE E
14
C
eod :
a
F
u
lt
Low voltage at stop
Corrective Actions:
1. Check if the input voltage is normal
2. Check for possible sudden load
aPh Ese sLo s EEEE
EFEE E15
C
eod :
a
F
u
l
t
Phase loss
Corrective Actions:
Check Power Source Input if all 3 input phases are
connected without loose contacts.
BIG OTE rve eEHa Et E
EFEE E
16
C
eod :
aFult
IGBT overheating
IGBT temperature exceeds protection level
1 to15HP: 90
o
C
20 to 100HP: 100
o
C
Corrective Actions:
1. Ensure that the ambient temperature falls within the
specified temperature range.
2. Make sure that the ventilation holes are not
obstructed.
3. Remove any foreign objects from the heatsinks and
check for possible dirty heat sink fins.
4. Check the fan and clean it.
5. Provide enough spacing for adequate ventilation.
Call 1(800)985-6929 for Sales
Call 1(800)985-6929 for Sales
To Next Page
Loading...
Need help?
General