Chapter 4 Parameters|VFD-VL
4-28
The first time you can set a password directly. After successful setting of password the display
will show 1.
Be sure to record the password for later use.
To cancel the parameter lock, set the parameter to 0 after inputting correct password into Pr.
00-07.
The password consists of min. 2 digits and max. 5 digits.
How to make the password valid again after decoding by Pr.00-07:
Method 1: Re-input original password into Pr.00-08 (Or you can enter a new password if you
want to use a changed or new one).
Method 2: After rebooting, password function will be recovered.
Password Decode Flow Chart
Password Setting Decoding Flow Chart Forgetting Passwrod
00-08
Displays 01 when
entering correct
password into
Pr.00-08.
Displays 00 when
entering correct
password into
Pr.00-07.
00-08
After entering 9999, press
twice to decode. The parameter
setting will be set to factory setting.
00-07
PROG
DATA
3 chances to enter the correct password.
1st time displays "01" if password is incorrect.
2nd time displays "02", if password is incorrect.
3rd time displays "P code"(blinking)
If the password was entered incorrectly after
three tries, the keypad will be locked.
Turn the power OFF/ON to re-enter the password.
Incorrect Password
END
Displays 00 when
entering correct
password into
Pr.00-07.
Correct Password
END
00-07
00-0800-08
00-07
Call 1(800)985-6929 for Sales
Call 1(800)985-6929 for Sales
To Next Page
Loading...
