Denon AVR-X500 Owner's Manual

48
Appendix
TipsSettingsConnections
Contents
Front panel Display Rear panel IndexRemote
Playback
Adjusting the volume of groups of
speakers (Fader function)
This function lets you adjust (fade) the sound all at once from the front
(front speaker / center speaker) or rear (surround speaker).
The fader can be adjusted until the volume of the speaker is adjusted to
the lowest value of –12 dB.
1
Press CH LEVEL.
The “Levels” screen is displayed on the TV screen.
2
Press i to select “Fader”.
3
Use o p to select the speaker.
4
Use o p to adjust the volume.
%
•The fader function does not aect the subwoofer.

Denon AVR-X500 Specifications

General

Receiver type	-
Frequency range	10 - 100000 Hz
Pre-out channels	1 SW
Speaker selector	No
Input sensitivity	200 mV
Pre-out connectivity	Yes
Audio output channels	5.1 channels
Signal-to-Noise Ratio (SNR)	98 dB
Total Harmonic Distortion (THD)	0.08 %
Power output per channel (1KHz@6 Ohm)	140 W
Power output per channel (20-20KHz@8 Ohm)	75 W
HDMI in	4
Audio (L/R) in	3
Composite video in	2
Ethernet LAN (RJ-45) ports	0
Number of HDMI outputs	1
Connectivity technology	Wired
Speakers connectivity type	Clamp terminals
Multichannel pre out connectivity	RCA
FM band range	87.5 - 108 MHz
Supported radio bands	AM, FM
Product color	Black
Audio decoders	Dolby Digital EX, Dolby Pro Logic IIx, Dolby TrueHD, DTS 96/24, DTS-ES, DTS-HD Master Audio
Apple docking compatibility	Not supported
Number of products included	1 pc(s)
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.3 W
Power consumption (typical)	330 W
Cables included	AC

Weight and Dimensions

Depth	319 mm
Width	434 mm
Height	151 mm
Weight	7900 g