71
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
Switching between PAL and NTSC signal formats
Set the video signal format to be output for the TV you are using.
•The factory setting is “PAL”.
SOURCE SELECT 1
SOURCE SELECT 0
STAT US
1
Press and hold STATUS and SOURCE SELECT 0 for at
least 3 seconds.
“V.Format:<PAL>” appears on the display.
2
Use SOURCE SELECT 0 1 and set the video signal
format.
3
Press STATUS to complete the setting.
%
•When a format other than the video format of the connected TV is set, the picture
will not be displayed properly.
To Next Page
Loading...
