Denon AVR-X500

59
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
Crossovers
Set in accordance with the lower limit frequency of the base frequencies
that can be played back through each speaker.
2 Set the crossover frequency
40Hz / 60Hz / 80Hz (Default) / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz /
200Hz / 250Hz
%
•“Crossovers” can be set when the “SW Mode” (vpage59) setting is
“LFE+Main”, or when you have a speaker that is set to “Small”.
•The default crossover frequency is “80Hz”, which will work best with the
widest variety of speakers. We recommend setting to a higher frequency that
the crossover frequency when small speakers are used. For example, set to
“250Hz” when the frequency range of the speakers is 250 Hz – 20 kHz.
•For speakers set to “Small”, low frequency content below the crossover
frequency is attenuated to the speakers and the low bass content is then
re-delivered to the subwoofer, or the front (L/R) speakers if they have been
set to Large.
Bass
Set subwoofer and LFE signal range playback.
2 LPF for LFE
Set LFE signal playback range. Set this when you want to change the
playback frequency (low pass filter point) of the subwoofer.
80Hz / 90Hz / 100Hz / 110Hz / 120Hz (Default) / 150Hz / 200Hz / 250Hz
2 SW Mode
Select low range signals to be reproduced by subwoofer.
LFE : The low range signal of the channel set to “Small” speaker size is
added to the LFE signal output from the subwoofer.
LFE+Main (Default) : The low range signal of all channels is added to
the LFE signal output from the subwoofer. This is
usually the best setting for most systems.
%
•“SW Mode” can be set when “Speaker Config.” – “Subwoofer”
(vpage57) is set to other than “No”.
•Play music or a movie source and select the mode oering the strongest
bass.
•If “Front” and “Center” for “Speaker Config.” (vpage57) are set to
“Large”, and “SW Mode” is set to “LFE”, no sound may be output from the
subwoofers, depending on the input signal or selected surround mode. Select
“LFE+Main” if you want the bass signals to always be produced from the
subwoofer.