Denon AVR-X500

60
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
Volume
Set the volume setting.
2 Scale
Set how volume is displayed.
0 – 98 (Default) : Display in the range 0 (Min) to 98.
–79.5dB – 18.0dB : Display ---dB (Min), in the range –79.5 dB to 18.0
dB.
2 Limit
Make a setting for maximum volume.
60 (–20dB) / 70 (–10dB) / 80 (0dB)
O (Default)
%
•If “Scale” is set to “–79.5dB – 18.0dB”, the value in ( ) is displayed.
2 Power On Level
Define the volume setting that is active when the power is turned on.
Last (Default) : Use the memorized setting from the last session.
Mute : Always use the muting on condition when power is turned on.
1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
General
Make various other settings.
2 Mute Level
Set the amount of attenuation when muting is on.
Full (Default) : The sound is muted entirely.
–40dB : The sound is attenuated by 40 dB down.
–20dB : The sound is attenuated by 20 dB down.
HDMI
Make settings for HDMI video/audio output.
NOTE
•When “Pass Through” is set to “On”, it consumes more standby power. If you are
not using this unit for an extended period, it is recommended that you unplug the
power cord from the power outlet.
2 HDMI Audio Out
Select HDMI audio output device.
AVR (Default) : Play back through speakers connected to the unit.
TV : Play back through TV connected to the unit.
%
•If “TV” is selected, only an HDMI audio signal is output from the TV.