DENTSPLY MULTIMAT Touch - Setup and First Use; Unpacking; Check Accessories; Setup

12
3. Setup and first use
3.1 Unpacking
" First, please check the "Shockwatch" label on the carton. If it red colored, the impact
energy during transport was higher than allowed and your unit could be damaged. Please
contact us if the furnace is not operational.
" Open the packaging and unpack the Multimat
®
Touch carefully.
3.2 Check accessories
" Check that the delivery is complete. The following accessories will be supplied with each
Multimat
®
Touch:
- 1 mains connection cable
- 1 sagger tray
- 1 firing platform
- 1 tweezers
- Directions for Use
" For the Multimat
®
Touch&Press, the following accessories will come on top:
- 1 pressing platform
- 1 filter regulator with pressure gauge and compressed air hose
For pressing of the FAC pressing porcelain, you also need an aluminium oxide plunger,
investment paper and a spruing set. These items are part of the FAC complete kit. If you
need single items, please order with the following numbers:
D430112 FAC spruing set large
D430114 FAC aluminium oxide plungers
D430115 FAC investment paper
" Note any transport damage.
" If the delivery is incomplete or has been damaged in transit, contact your supplier.
3.3 Setup
" Place the furnace onto a suitable setup location, and ensure that a sufficient distance
between the unit and the wall is maintained (25 cm minimum).
" Place the firing platform onto the firing platform carrier.
" Connect the mains plug of the Dentsply vacuum pump to the vacuum pump socket on the
furnace, and push the vacuum hose onto the hose adapter on the furnace. The arrow on
the filter must be in the direction of the vacuum pump.
" If you have a Multimat
®
Touch&Press furnace, connect the air hose of the filter pressure
control to the bulkhead connector of the furnace.
" Connect the filter pressure control to the compressed air system and set the press
furnace to its operating pressure of 2.7 bar (the pressure has been preset to 2.7 bar by
the manufacturer).
-
3.4 First use
" Before establishing the connection, check whether the mains voltage of your power
supply corresponds to the mains voltage specified on the rear plate.
If the mains voltage of your power supply is out of the voltage range mentioned on the
rear plate of your furnace you have to use a voltage constanter.