DENTSPLY MULTIMAT Touch - Firing Table for Finesse Metal Ceramics (Detrey Mode)

50
9.2 Firing table for Finesse metal ceramics (DeTrey Mode)
(Use honey comb)
Prog #. Program
Description
Preheat/
Low
Temp.
°C
Drying
time
min.
Preheat.
min.
Vacuum
Level
hPa
Rate of
Temp.
Rise
°C/Min.
Firing /
High
Temp.:
° C
Vacuum
Time
Min.
Firing
time
min.
311 D-FIN-Powder
Opaque
450 03:00 03:00 50 90 800 00:30 01:00
312 D-FIN-Paste
Opaque
450 05:00 03:00 50 90 790 00:06 00:30
313 D-FIN-Joint
Opaque /
Margin/margin
mod.
675 03:00 07:00 50 35 770 00:06 00:30
314 D-FIN-
Correction
Opaque
450 05:00 03:00 50 90 760 00:06 00:30
315 D-FIN-1.Main
Firing
Opaque dentine,
Dentine,
Dentine effect,
enamel,
gums
450 05:00 05:00 50 35 760 00:06 00:30
316 D-FIN-2. Main
Firing
Opaque dentine,
Dentine,
Dentine effect,
enamel,
gums
450 05:00 05:00 50 35 750 00:06 00:30
317 D-FIN-
Correction
Firing
450 05:00 05:00 50 55 730 00:06 00:30
318 D-FIN-Glaze
firing/
Stains '
450 03:00 03:00 - 70 750 - 00:06
319 D-FAC-repair
porcelain
450 05:00 05:00 50 35 810 00:06 00:30
320 D-FAC-Shade
stain porcelain
450 03:00 01:00 -. 100 730 -- 01:00
D = DeTrey Mode
FIN = Finesse metal ceramic
FAC = Finesse All Ceramic
' depending on desired grade of glaze
Caution!
Firing parameters that are not listed in the firing table should be set to "0" during
value input.
Attention: Do not use pressing platform for firing.
Note: If necessary, carry out a firing test and adjust firing temperatures or times.
Incase of firing a larger number of objects it may be necessary to adjust the firing
temperature or the holding time.