32
5.7 Start a program
1. Open the firing chamber with the Up key "$" on the right-hand control panel (if it is not
already opened).
2. Touch the button "start/stop". The furnace will switch over to the firing curve screen.
The firing curve visualizes all firing sections. Initially, the firing curve will be shown empty
underneath which, starting on the left, is being filled up during the firing sequence with color.
At the bottom of the firing curve, the time periods for the firing sections are shown. They are
visibly counted down to zero.
In its right-hand margin the screen display shows symbols for printer or PC (if pre - selected
in the basic settings).
While firing is in progress, the following functions can be chosen:
Function Action
a. View touch button "$", then”%” to close again
b. Cancel view function touch button "start/stop"
c. Cancel program touch button "start/stop"
d. Cancel vacuum touch button "C"
e. Change firing parameters soft key "&"
f. Acknowledge messages touch button "C"
g. Activate Night Mode touch button “Night Mode”
Programming of the firing parameters in the various individual firing procedures is always the
same.
5.8 Standard functions
5.8.1 Recall a program
1. Press the touch button "R"
2. Enter the program number.
3. If the program number is 99 or below press “R” again
4. Press soft key "List" and scroll through the programs listed. The required program will be
displayed directly by pressing the respective associated touch button.
5.8.2 Save program
Save your program by pressing the button "S". The firing parameters entered will be checked
for feasibility. Firing parameters that are not feasible will be shown in the info field. Confirm
error message with “C”. Correct firing parameters by entering new data. If all firing
parameters are accepted, the control system will propose to use the next available program
number as a storage location. If you agree and accept this proposition, then press the button
"S" again.
Alternatively, if you wish to save a program individually, then use the numeric keypad to
enter a different program number. The firing parameters will be saved. By entering a new
number that already exists, the furnace asks you if want the old program with this number to
be overwritten.
To Next Page
Loading...
