DENTSPLY MULTIMAT Touch - Program Sorting According to Name or Program Number; Change Standard Drying Position and Steps; Changing the Tempering Position of the Firing Chamber

39
6.12 Program sorting according to name or program number
(Main menu Section 4.5.1)
This function enables the programs to be sorted according to name or program number. This
function is very helpful if the programs are prefixed by a letter for identification.
Program sorting
1. Press the sensor button "M"
2. Press the sensor button "Configuration"
3. Press the sensor button "Sorting" and select the name or number.
4. Press the sensor button "M" frequently enough until the preceding program appears.
Notice: This function can only be used in association with the Latin alphabet.
6.13 Change standard drying position and steps
This function enables the standard drying position and the number of steps with which the
standard drying position should be reached proceeding from the upper end position to be
changed.
Set new drying position
1. Double press in the program on the white Drying Bar.( Do not press the sensor key!) A
selection screen appears.
2. Press the yellow sensor button "Drying position"
3. Enter the new drying position in "mm" using the numeric keypad.
4. With a drying position smaller than 100mm, press the "Drying position" sensor button
again.
Note: The drying position is adjustable from 0 to 150 mm. 0 mm is the startposition in the
basic menu.
Setting steps
1. Press the yellow sensor button "Steps"
2. Enter the number of steps on the numeric keypad.
3. Press the "Left arrow". The program is displayed again.
Note: To permanently retain the changed drying parameters, the program must be stored
before the start. The new drying parameters apply only for the changed program. All other
programs remain unaffected by this.
Attention: It is highly recommended not to change the original preset standardized drying
positions
.
6.14
Changing the position of the chamber for tempering
This allows the chamber position for tempering to be changed.
Set the new tempering position
1. Double press in the program on the white "Tempering" Bar. A selection screen appears.
2. Press the yellow sensor button "Tempering position"
3. Enter the new tempering position in "mm" on the numeric keypad.
4. At tempering positions smaller than 100 mm press the "Tempering position" sensor
button again.
5. Press the "Left arrow". The program is displayed again.
Note: To permanently retain the changed tempering position, the program must be stored