DENTSPLY MULTIMAT Touch - Reset Muffle Operating Hours; Statistical Data; Smart Card; Delete Programs

26
When ordering a replacement heating muffle, always state the voltage on the nameplate of
the furnace.
100 – 240 V = 100 V Muffle
100; 110; 115; 125 V = 100 V Muffle
230 V = 230 V Muffle
4.5.2.5 Reset Muffle Operating Hours
After changing the muffle the muffle operating hours can be reset to Zero.
1. Select “Muffle operating hours”
2. Input code 6070 using the numeric keypad
3. Select “Muffle operating hours” again
4. Confirm reset by touch sensor button “C”
4.5.2.6 Statistical data
Furnace operating hours
Pump operating hours
Lift cycles
Firing cycles
These values can only be read, and are used by the control system as reference source for
maintenance instructions.
4.5.3 Smart Card
The Smart Card is used to save individual programs and to transfer to other Multimat
®
Touch and Multimat
®
Touch&Press furnaces. A detailed description is included in the
Smart Card Kit (see also Special functions 6.16.2 and 6.16.3).
4.5.4 Delete programs
4.5.4.1 Single program
1. Press sensor button “M”
2. Press sensor button “Delete programs”
3. Press sensor button “Delete single program”
4. Enter program number of the program which should be deleted.
5. Delete program by touching sensor button “Delete single program” again.