DENTSPLY MULTIMAT Touch - Changing a Program; Changing a Program During a Firing Sequence (Overwrite); Copy Program; Deleting Programs

33
5.8.3 Changing a program
Change your program by direct selection of the firing parameter and subsequent input of the
new value by means of the numeric input block. The new value will be accepted by:
a. renewed selection of the firing parameter
b. selecting a different firing parameter
c. save
5.8.4 Changing a program during a firing sequence (Overwrite)
All firing sections not yet processed may be changed while firing is in progress. This is
effected by means of soft key "&" in the firing curve screen. The firing parameter Screen
appears. This screen also allows the firing progress to be traced. After the firing parameters
shown on the information bar are executed, the yellow sensor button next to the bar will
disappear. Activated parameters cannot be changed. Parameters which have not yet been
activated can be changed. Select parameter which has to be changed. The respective
parameter value will be displayed on a blue background. User can change this value by
means of the numeric keypad. Any change made will be accepted by renewed selection of
the touch button for the respective parameter (more details see 5.8.3). The change made is a
one-time change only, will not be saved, and only applies to the current firing sequence. After
the last change has been made you can return to the firing curve screen. When firing has
been completed, the original parameters will be displayed again.
5.8.5 Copy program
Recall “R” the program which should be copied. Copy the program by pressing the touch
button "S" and entering a new program number by means of the numeric keypad. If the
program number is already in use, a relevant message will appear. You will be asked to
overwrite or not. If you press touch button "S" twice, the program will be automatically stored
under the next available program number.
5.8.6 Deleting programs
(cf. Section 4.5.4)