DENTSPLY MULTIMAT Touch - Installation and Safety Notes; Automatic Self-Test

14
3.4.4 Installation and safety notes
On the screen the most important
installation notes appear as well as the
compliance note to follow the installation
and safety information in the Directions
for Use.
Confirm with the OK button and touch the
Right Arrow key.
3.4.5 Automatic Self-Test
The automatic self-test test will be carried out at each new start of the furnace when taken
from mains and plugged in again.
Note: When the left arrow key is operated, a safety interval of 5 seconds between the "Basic
Set-Up" and "Automatic Self-Test" is set to prevent the automatic self test being selected by
accident. The Automatic Self-Test can be stopped by touching “C” immediately.
The automatic self-test will be carried out
automatically.
The result of the test will be indicated in
the text line.
If the test is without any error, the test
positions are ticked off. After completion,
the screen display "Basic Settings" will
appear.
If the test is not successfully, a red cross
will appear next to the relevant test
position and a corresponding note is
displayed in the text line. In such cases,
confirm by touching the sensor button
"OK".