16
3.4.6.5 Date
1. Touch the yellow sensor button "Date"
2. Enter a 8-digit number for day/month/year using the numeric keypad
3.4.6.6 Acoustic signal
Touch the yellow sensor button to activate or deactivate the signal.
3.4.6.7 Idle temperature
This function is used to save energy and to reduce the surface temperature of the furnace.
Note: The idle temperature is preset to 400 °C and cannot be set higher than 600 °C. The
idle temperature has to be at least 25 °C lower than the low temperature.
Touch the sensor button to change the idle temperature as follows:
1. Touch the sensor button
2. Input the new temperature using the numeric keypad.
3.4.6.8 Max-Temp
This function is used to set the upper temperature limit.
Note: It is recommended to limit the temperature to avoid muffle exposure to thermal
stresses.
Touch the yellow sensor button to change the maximum temperature as follows:
1. Touch the sensor button.
2. Input the new temperature using the numeric keypad.
3. Touch the "Max-Temp" sensor button again (or select another sensor button). The
temperature will be accepted. (Sensor changes into yellow again.)
3.4.6.9 Data output
If the symbols “printer” or “PC” are activated, all target/actual values are automatically
transferred to printer/PC at the end of each firing cycle (as long as a printer of PC with quality
assurance program is connected).
If the printer or PC symbols are not shown, then only the target values for each firing cycle
will be shown in the display and printed, after activating the PR/PC sensor button at the
bottom of the screen (firing data screen).
Note: MMT-PC-Quality assurement program is optional.
3.4.6.10 Screen brightness
Press the sensor button "◐+" for increasing brightness and "◐-" for decreasing brightness.
Press the sensor button "#" when you have completed entering the basic settings. The
furnace will change over into the next screen.
To Next Page
Loading...
