41
1. Insert the Smart Card into the slot on the right hand side of the furnace (Chip towards the
rear).
2. Touch the sensor button “M” on the numeric pad
3. Choose the option “Smart Card”.
4. Choose the option “Format Smart Card”.
5. Confirm your choice by touching “S” = Yes (end with “C” = no)
6. The procedure takes approx. 5-10 sec).
7. Confirm the Card has been successfully formatted with “C”.
8. Now you can save individual programs on the card.
6.16.2 Transfer of program from furnace → Smart Card
1. Insert the Smart Card into the slot on the right hand side of the furnace (Chip towards the
rear).
2. Touch the sensor button “M” on the numeric pad.
3. Choose the option “Smart Card”.
4. Touch the sensor button “furnace → Smart Card”
5. Choose the individual programs form the list shown or touch the sensor button “All” which
is situated in the soft key bar.
6. Touch the sensor button “ → Card” in the soft key bar.
7. Confirm with “C”.
Note: The storage capacity of the Smart Card is limited to approx. 5 years. Please back up
your current programs regularly.
To Next Page
Loading...
