Dickey-John Control Point - Warranty

OPERATOR'S MANUAL
102/CALIBRATION DATA RECORD SHEET CONTROL POINT
®
11001-1489-201702 Rev B
CALIBRATION DATA
RECORD SHEET
Parameter Salt Sand Mix A Mix B
Granular Material __________ __________ __________ __________
STEP METHD __________ __________ __________ __________
APP START/RATE 1 __________ __________ __________ __________
IC/DC STP/RATE 2 __________ __________ __________ __________
MIN APP/RATE 3 __________ __________ __________ __________
MAX APP/RATE 4 __________ __________ __________ __________
RATE 5 __________ __________ __________ __________
RATE 6 __________ __________ __________ __________
RATE 7 __________ __________ __________ __________
RATE 8 __________ __________ __________ __________
RATE 9 __________ __________ __________ __________
RATE 10 __________ __________ __________ __________
BLST RATE __________ __________ __________ __________
CHN LBL __________ __________ __________ __________
GRANULAR APPLICATION RATE (F2)
Parameter Liquid 1 Liquid 2 Liquid 3 Liquid 4
Liquid Material
K-FACTOR/DENSITY __________ __________ __________ __________
DRV FREQ __________ __________ __________ __________
PWM OFFSET __________ __________ __________ __________
PWM SAT. __________ __________ __________ __________
SYS RSPNS __________ __________ __________ __________
VALV BOOST __________ __________ __________ __________
AFILT __________ __________ __________ __________
TANK LEVEL __________ __________ __________ __________
VALVE LOCK __________ __________ __________ __________
Boom
SECN ENBLED __________ __________ __________ __________
12V ON __________ __________ __________ __________
NUM OF NZZLS __________ __________ __________ __________
NZZLE SPCNG __________ __________ __________ __________
PAUSE ENABLE __________ __________ __________ __________
BOOM INPUT __________ __________ __________ __________
MISCELLANEOUS (F12)
UNLOAD _____________
NO GND SPD _____________
DRV FREQ _____________
PULSE FDBK _____________
PWM OFFSET _____________
PWM SAT _____________
GSRS ENABLE _____________
SPINNER CONFIGURATION (F8)
LIQUID CONFIGURATION (F5)
LIQUID APPLICATION RATE (F4)
MISCELLANEOUS (F12)
MAX SPEED __________
MANUAL ON __________
MANUAL DRIVER __________
MANUAL SPEED __________
START UP __________
SHUT OFF SPD __________
2 AXLES __________
CONSTANT __________
GROUND SPEED CONFIGURATION (F7)