OPERATOR’S MANUAL
Control Point
®
11001-1489-201702 Rev B
START-UP AND FAMILIARIZATION / 23
only with the button pressed). A timed blast period can be terminated
early by activating the Blast button a second time. Blasting can be
initiated with the master switch in AUTO or OFF.With a timed blast
cycle, a programmed minimum ground speed establishes the material
flow rate until that speed is exceeded by the actual ground speed.
MASTER SWITCH IN THE UNLOAD POSITION
The Unload position of the master switch is used to quickly remove material
from the truck. There must be no ground speed for the Unload function to
operate. If ground speed is dedicated, the Unload feature will not work.
If the spinner is programmed to operate during UNLOAD, be
sure that no one is in the vicinity before performing this
procedure to avoid possible injury!
1. Back up to the appropriate location and momentarily press Unload.The
actuators open fully for those channels turned on from the Switch
Module.
2. To stop the unload operation, move the master switch to the OFF
position.
3. If ground speed exceeds longer than 10 seconds, unload will be
terminated. To clear, move the master switch to OFF.
To Next Page
Loading...
