Dickey-John Control Point - Air Temperature Sensor Calibration

OPERATOR’S MANUAL
Control Point ®
11001-1489-201702 Rev B
40 / KEYBOARD PROGRAMMING
AIR TEMPERATURE SENSOR CALIBRATION
Press C to start the Temperature Sensor Adapter automatic calibration
procedure. Calibration lasts approximately 10-20 seconds. Calibration is
complete when the Air Temperature Sensor menu displays.
IMPORTANT: The RoadWatch™ temperature sensor or Surface
Patrol™ temperature sensor must be disconnected and
the Temperature Sensor Adapter connected to the main
harness for successful calibration. If the Temperature
Sensor Adapter is disconnected when calibration is
performed, an error screen will display.