OPERATOR’S MANUAL
Control Point
®
11001-1489-201702 Rev B
KEYBOARD PROGRAMMING / 67
MONITOR & RESET ACCUMULATORS (F9)
Accumulators store current run and season run totals of distance traveled,
material amount, and time spent spreading materials in both the AUTO and
BLAST modes. Separate totals are accumulated for each material. All of the
current and season accumulators can be cleared (zeroed) from this mode
(F9).
1. From the keyboard, press Function key F9 to display the Accumulators
screen, refer to (Figure 44). Four selections appear - Granular, Liquid,
Pause and Enable Clr from Current Total Screen.
2. Press 1 for GRANULAR or 2 for LIQUID to monitor the accumulators
for corresponding materials. When pressing either the 1 or 2 key, four
materials display for monitoring.
3. Press 3 PAUSE to display the current and season miles/hours driven in
a Pause state.
4. Press 4 to enable/disable the clearing of the CURRENT TOTALS
screen in the Operate mode.
5. If GRANULAR or LIQUID is selected from Step 2 above, select the
material by pressing the corresponding key. A divided screen appears
showing CURRENT totals (top half) and SEASON totals (bottom half).
To clear CURRENT totals, press C. To clear both CURRENT and
SEASON totals, press S. The season totals cannot be cleared
separately.
To clear accumulators for other materials, press F9 to return to the
ACCUMULATOR screen and select the next material. Continue as
before to clear the totals.
To enable clearing the CURRENT TOTALS screen in the
OPERATE mode, press F9 to return to the ACCUMULATORS
screen and then the 4 key to select the ENABLE/DISABLE CLR
FROM CURRENT TOTALS SCREEN
6. To change status from enable or disable: YES causes the ENABLE/
DISABLE CLEAR selection to alternate. A setting of NO leaves the
ENABLE/DISABLE CLEAR status unchanged.
To Next Page
Loading...
