Dickey-John Control Point - Page 90

OPERATOR’S MANUAL
Control Point ®
11001-1489-201702 Rev B
SYSTEM CALIBRATION / 85
Figure 50
Spinner Width Calibration
CALIBRATION MENU
SELECT A MENU ITEM
1 GRANULAR
2 LIQUID
3. SPINNER WIDTH
SPIN WIDTH CALIBRATION
SELECT A MENU ITEM
1 SALT ENABLED
2 SAND ENABLED
3 MIX A DISABLED
4 MIX B DISABLED
SALT WIDTHS
NOT CALIBRATED
POSITION 20 0.0 FT
POSITION 40 0.0 FT
POSITION 60 0.0 FT
POSITION 80 0.0 FT
POSITION 100 0.0 FT
– – WARNING – –
CALIBRATE STARTS
MATERIAL FLOW
PRESS R TO RUN
Press Function Key F6
(CAL)