Interfaces Wireless Wide Area Networks (WWANs)
IX10 User Guide
107
b. Create a label for the test:
(config network interface my_wan surelink tests 1)> label string
(config network interface my_wan surelink tests 1)>
c. if the test should apply to both IPv6 rather than IPv4, enable IPv6:
(config network interface my_wan surelink tests 1)> ipv6 true
(config network interface my_wan surelink tests 1)>
d. Set the test type:
(config network interface my_wan surelink tests 1)> test value
(config network interface my_wan surelink tests 1)>
where value is one of:
n
ping: Uses ICMP to determine connectivity.
If ping is selected, complete the following:
l
Set the ping_method:
(config network interface my_wan surelink tests 1)> ping_
method value
(config network interface my_wan surelink tests 1)>
where value is one of:
o
hostname: The hostname or IP address of an external server.
o
Set ping_host to the hostname or IP address of the server:
(config network interface my_wan surelink tests 1)> ping_
host hostname/IP_address
(config network interface my_wan surelink tests 1)>
o
interface_gateway. If set, an initial traceroute is sent to the hostname or IP
address configured in the SureLink advanced settings, and then the first hop
in that route is used for the ping test.
o
interface_address.
o
interface_dns: The interface's DNS server.
l
Set the number of bytes to send as part of the ping payload:
(config network interface my_wan ipsec tunnel ipsec_example
surelink tests 1)> ping_size int
(config network interface my_wan surelink tests 1)>
n
dns: Performs a DNS query to the named DNS server.
If dns is set, set the IPv4 or IPv6 address of the DNS server:
(config network interface my_wan surelink tests 1)> dns_server
IP_address
(config network interface my_wan surelink tests 1)>
To Next Page
Loading...
Need help?
General
