Interfaces Wireless Wide Area Networks (WWANs)
IX10 User Guide
121
SIM
---
SIM Slot : 1
SIM Status : ready
IMSI : 61582122197895
ICCID : 26587628655003992180
SIM Provider : AT&T
4G
--
RSRQ : Good (-11.0 dB)
RSRP : Good (-93.0 dBm)
RSSI : Excellent (-64.0 dBm)
SNR : Good (6.4 dB)
>
Unlock a SIM card
A SIMcard can be locked if a user tries to set an invalid PINfor the SIMcard too many times. In
addition, some cellular carriers require a SIMPINto be added before the SIMcard can be used. If the
SIMcard is locked, the IX10 device cannot make a cellular connection.
Command line
To unlock a SIM card:
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, use the modem puk unlock command to set a new PINfor the SIM
card:
> modem puk unlock puk_code new_pin modem_name
>
For example, to unlock a SIMcard in the modem named modem with PUK code 12345678,
and set the new SIM PIN to 1234:
> modem puk unlock 12345678 1234 modem
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Note If the SIMremains in a locked state after using the unlock command, contact your cellular
carrier.