Serial port Configure UDP serial mode
IX10 User Guide
221
n
even
n
odd
n
none
The default is none.
10. Set the stop bits used by the device to which you want to connect:
(config)>serial port1 label stopbits bits
(config)>
11. Set the type of flow control used by the device to which you want to connect:
(config)>serial port1 label flow type
(config)
Allowed values are:
n
none
n
rts/cts
n
xon/xoff
The default is none.
12. (Optional) Configure data framing:
a. Enable data framing:
(config)>serial port1 framing enable true
(config)
b. Set the maximum size of the packet:
(config)>serial port1 framing max_count int
(config)
The default is 1024.
c. Set the length of time the device should wait before sending the packet:
(config)>serial port1 framing idle_time value
(config)
where value is in milliseconds (ms) or seconds (s). The maximum value is 60s.
d. Set the end pattern. The packet is sent when this pattern is received from the serial port:
(config)>serial port1 framing end_pattern backslash-escaped-string
(config)
e. Set the strip end pattern if you want to remove the end pattern from the packet before it is
sent:
(config)>serial port1 framing strip_pattern true
(config)
To Next Page
Loading...
Need help?
General
