Digi IX10

Virtual Private Networks (VPN) IPsec
IX10 User Guide
366
c. If type is set to url, set the URL that should be used:
(config network scep_client scep_client_name)> crl url value
(config network scep_client scep_client_name)>
11. Configure certificate renewal:
a. To enable the creation of a new private key for renewal requests:
(config network scep_client scep_client_name)> renewal new_key true
(config network scep_client scep_client_name)>
b. The use of a client certificate for renewal requests is enabled by default. To disable:
(config network scep_client scep_client_name)> renewal use_client_cert
false
(config network scep_client scep_client_name)>
12. Set the maximum time that the device will poll the SCEP server, when operating in manual
mode:
(config network scep_client scep_client_name)> max_poll_time value
(config network scep_client scep_client_name)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the format
number{w|d|h|m|s}.
For example, to set max_poll_time to ten minutes, enter either 10m or 600s:
(config network scep_client scep_client_name)> max_poll_time 600s
(config network scep_client scep_client_name)>
The default is 1d.
13. Set the amount of time that the device should wait between polling attempts, when operating
in manual mode:
(config network scep_client scep_client_name)> polling_interval value
(config network scep_client scep_client_name)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the format
number{w|d|h|m|s}.
For example, to set polling_interval to ten minutes, enter either 10m or 600s:
(config network scep_client scep_client_name)> polling_interval 600s
(config network scep_client scep_client_name)>
The default is 5s.
14. Set the bit size of the private key:
(config network scep_client scep_client_name)> key_length int
(config network scep_client scep_client_name)>
The default is 2048.